Close



Results 1 to 2 of 2

Hybrid View

  1. #1

    FLSUN Prusa i3 extruder won't heat past 125 degrees C aftyer..

    Hi guys..

    I did after a big meltdown of my nozzle and thermister change the ceramic heaterpin and thermister.
    start up again and the extruder heat up til 125 degree
    i did use 3 new heating elements 12 v 40 watt 3,6 ohm (al same)
    and i did test 2 NTC 100K

    so i pulling my hairs out

    even if i direct put 12 v to the element (without the board ) it stuck on 125 degrees
    drives me crazy!!

    annyone know what i can do?

    greetz

  2. #2
    i did find the error.. the heatingblock was touching the cooling part and there should be 5 mm in between.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •