Close
Flash Forge Guider



Results 1 to 1 of 1
  1. #1

    need help with first layer after raft

    i need to use the raft for printing this little part, the first layer of the part look under-extruded, with gap
    test1.jpg

    Then I tried to increase the bottom layers for 2 to 5, same identical result
    test2.jpg

    Also tried to increase "above raft speed" from 50 to 100%
    test3.jpg

    With no raft the part is obviously good
    test4.jpg

    I am using S3D 4.1.1
    Last edited by zfrenchy; 05-05-2019 at 11:00 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •