heating issue

[cripto101]

I did a search but could not find much to help me on this. I had a power supply burn out due to a faulty fan. I replaced it with a mean well nes 350 12. After i replaced the power supply the bed and hotend became very slow to heat up. This was not an issue prior to the change. Once the hot end hits 140 degrees with a target of 200 and the bed hits about 48 with a target of 60 degrees I get an E1 heating failed error. I have checked the voltage on the power supply and currently have it tuned to 13 volts. I saw somewhere that it could be due to a thermal runaway protection setting in marlin but I am not sure what to look for. Does anyone have any ideas? I have my config.h posted so any help would be amazing. Thank you for your time.