Close



Results 1 to 1 of 1

Threaded View

  1. #1

    Unhappy Strange printing issue

    I've recently rebuilt a davinci 1.0 with a RAMPs board with Marlin 1.1.x-bugfix and E3D V6 hotend so it's not a davinci anymore. I'm running into a very strange printing issue, the likes of which I've not been able to find on my friend Google. The printing starts off at roughly the correct dimension, shrinks on one of side of the X axis, seems to get worse, then after about 10 or so layers, it prints perfectly (within .1mm). The g-code seems fine from what I've been able to tell with the 2 viewers (built into Cura and Octoprint)

    20190313_170829.jpg20190313_170856.jpg
    Attached Images Attached Images

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •