Subscribe to Our Newsletter Advertise
Close



Results 1 to 8 of 8

Threaded View

  1. 03-06-2019, 11:12 PM #1
    JackMcConick
    JackMcConick is offline
    Student
    Join Date
    Mar 2019
    Posts
    3

    Heat gun or Blow torch for post processing?

    After breaking off supports or sanding, I usually use a lighter to heat up the plastic to remove the white discoloration on my prints.I'm thinking about one of those small handheld torches or a hot gun. Any thoughts?
    Last edited by JackMcConick; 03-13-2019 at 05:16 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules