Close



Results 1 to 4 of 4

Threaded View

  1. #1

    Makerbot Replicator Print Quality Troubleshooting _ Gaps in Top Layer

    Hello everyone,

    I am responsible for operating and maintaining 3 Makerbot Replicator printers (named A, B, and C) at my local college, and recently I have been having some print quality issues when using B and C. I haven't used A much; B and C have historically produced better prints. I am trying to print what we call "kit blocks". The prints I ran prior to the ones I am currently trying to run came out nearly perfect, so I thought I had found my "Goldilocks" settings. I have not changed the settings much if at all, and the test cube prints that I did before starting the kit blocks came out really well.

    Problem: There is some stringiness as well as layer separation/oozing, but most importantly, I have some very large gaps in the top layers. If you orient the part the same as it was on the print bed, you can see it is actually the same area that is being affected. I can't seem to attach pictures at this time.

    My settings are as follows:
    Infill: 5% hex
    Extruder temp: 215F
    Travel Speed: 150 mm/s
    Speed on shells and first layer: 10 mm/s
    Layer height: 0.2 mm
    Fan: 45-50%
    Shells: 3 with fixed start point
    Roof/Floor Thickness: both 1mm
    Retraction Distance: 1 mm
    Filament diameter: 1.72 mm
    No supports

    Room temperature is 77F, and we have cardboard boxes over the printers as well. I am printing with a raft and use painter's tape as well. I am fairly new to 3D printing, so any advice would be most helpful.
    Last edited by Adamantium Wolf; 02-19-2019 at 01:57 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •