Close



Results 1 to 1 of 1
  1. #1

    Crazy under extrusion with Slic3r and Ender 3

    Hi guys,

    I've got an Ender 3 , mostly stock except the bed which i've changed to an Ikea Mirror . cut to size.

    I've been trying Slic3r and ended up liking it more for how smooth top layers are printed with it, compared to CURA, although i have my cura settings on lock.

    I dialed in Slic3r as well to the full extent but for some reason when prints are narrower than 5-6mm it starts under extruding to the point where i barely see the extruder motor spinning and it looks like it does in the picture i attached.

    If i print it with Cura it comes out great. I've adjusted my steps/mm , adjusted extrusion / flow rate which was too high to begin with (had to go down to 89% ) , but slic3r is still driving me mad. Also both gcodes have M82 enabled.

    I don't know what else to check at this point.
    Attached Images Attached Images

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •