Newbie needs help from experienced printers - Anycubic I3 Mega

[Astar]

First of all I would like to say hello to everybody on this forum ! This is my first message on it, freshly registered.

I started to print some stuff for the last couple days and I have an issue with printing some holes. .STL from thinkercad if this is any help.

PLA+
215?C
Bed 65?C
0.2mm layer height
60mm/s
Retract speed 40mm/s
Retract distance 7mm

Normally, prints from it are pretty good but this one is pretty bad... Do you have an idea why ?

Thanks for you help anyway !
Cheers,

Djay