DaVinci Pro - "settings do not apply to material" message

[Malpaso]

Brand new at this, only about a week. Started with XYZ ABS filament, no problem. Went to Amazon PLA, no problem. Switched to Hatchbox PLA and started getting this message:

Your setting does not apply to the installed material.

I've varied the settings and get the message regardless. Anyone seen this before and can narrow down the supposedly bad setting?

[curious aardvark]

check in the slicer that you've got pla selected.

Thought the davinci used propriatary filament ?

[Malpaso]

The DaVinci uses proprietary filament and also allows for 3rd party filament, and that's where the problem was. At some point between prints, I put the proprietary filament cartridge back in the slot to store it. The printer must "see" it (there are conductors on the cartridge) even though I specified third party in the set up. Took it out and tried the print again, no problem.

[curious aardvark]

thought it had to be something like that :-)