I have been busy rebuilding the red car as a proper Racecar. Complete teardown and reassembly with LSX engine and supercharger. All happening right here: https://www.superchargerforums.com/t...x376-b15.9500/

We are hopefully going back to the track next Friday or the week after. At which point he will hopefully be able to break into the 10's. We shall see. I have also been building a racecar out of a mazda Miata here: https://www.superchargerforums.com/t...da-miata.9454/

I need to start printing in materials that can be inside of cars down here in the south Florida heat. Thus far for all I have done I have only played with the PLA and it warps if left in a car. What is better for not warping in the sun? ABS or PETG?