Close



Page 5 of 5 FirstFirst ... 345
Results 41 to 41 of 41
  1. #41
    Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    575
    Add Roberts_Clif on Thingiverse
    When I stated Printing PLA two years ago I was printing at 196C using this filament.


    I print it at 200-204C this was after having to change the larger Hot-end heater block with a smaller Heater Block.
    I cold not find the larger heater blocks, and purchased 10 of the smaller, so will have these for a while.

    PLA.jpg

    I also Have some ABS that I started printing ABS in 2018 an is has a lower than normal printing temperature.
    This is printed at 228C with really good results as shown in the image below...

    ABS.jpg

    Same Filament did not have an image of model using the ABS Silver.
    It amazed me as the ABS actually bridged better than the PLA

    FOB ABS.jpg
    Last edited by Roberts_Clif; 02-20-2019 at 08:38 PM.

Page 5 of 5 FirstFirst ... 345

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •