Close
Flash Forge Guider



Results 1 to 2 of 2
  1. #1

    Best way to remove support

    I printed a segmented fishing lure which turned out quite good, given that I am new to 3D printing, however I had a real problem getting the base layer and the support off of the lure. I actually broke a small piece of the lure off while trying to remove the support. What is the best way to do this? Would it come off easier if I heated it up a bit?

    Thanks

  2. #2
    PostProcess support removal machine

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •