Close



Results 1 to 1 of 1
  1. #1

    Retraction stringing between holes on print. First 3 layers.

    I'm having a first here recently. Retraction isn't happening between holes when printing. IMG_0616.jpg - This is happening on every layer. --- Any ideas. Printing PLA, 215 Hotend, prints perfectly, but this artifact happening on the top layer as well.
    Last edited by jhuff1979; 12-05-2018 at 11:59 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •