Subscribe to Our Newsletter Advertise
Close



Results 1 to 1 of 1
  1. 12-21-2018, 03:35 PM #1
    RobertR728
    RobertR728 is offline
    Student
    Join Date
    Nov 2018
    Posts
    28

    Help with MKS Gen L V1.0 Ender 3

    Hi all so when i connect to my new MKS GenL board i get the below picture. It says device has an issue. I have trouble programming ir because it shows under USB af a fault instead of as a com port.I have VP installed and when i connect to the old Ender 3 board i get a com port.I dont know what direction to go from here ?Help RobertUpdate it turns out being new got me again. I didn't know i needed to install the stepper drivers on this board. They are in the mail. Ya learn something everyday and sometimes every hour in the 3d print world
    Attached Images Attached Images
    Last edited by RobertR728; 01-01-2019 at 07:41 PM. Reason: Forgot the pic
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules