Close



Results 1 to 3 of 3
  1. #1

    Suggestions for Improving My Owl Print

    20181130_120030.jpg
    Am printing an owl to take the place of the cuckoo bird in one of my cuckoo clock designs. The post at the back is supposed to have a hole in it for the bird wire from the clock movement to go through. Am using Hatchbox wood PLA and a Makerbot Replicator 2X.

    Should I make a larger raft and add supports so the post prints correctly?

    Thanks for any help!

    Jodie

  2. #2
    Engineer-in-Training Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    381
    Add Roberts_Clif on Thingiverse
    Which Slicer are you using?
    Include your slicer settings.

    Yes I would include supports.

  3. #3
    I'm using Makerbot Desktop.

    Here are what I think are pertinent settings, but I can fetch more:


    OwlSettings1.JPGOwlSettings2.JPGOwlSettings3.JPG

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •