Close



Results 1 to 3 of 3
  1. #1

    Noob seeks help adjusting bed height

    Hi i wanted to get some opinions my bed height.While i know that we typically want to get as close to the bed as possible. I was wondering what the finished product of the very first pass should look like? Should it look like a bead of caulk, or mor flat than that? I'm adjusted downto the thickness of a piece of paper now. This is my first printer so i would be open to any advice about leveling the ender 3 bed.

    Thanks all
    RobertR728
    Attached Images Attached Images

  2. #2
    Engineer-in-Training Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    383
    Add Roberts_Clif on Thingiverse
    If you are using a .4mm Nozzle and printing with a layer height of .28mm.
    Your first line will look kind of like an oval it will be about .44 ~ .48 Wide and should be .28 in Height

  3. #3
    Beautiful thank you so much for the advice.

    RobertR728

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •