Close



Results 1 to 1 of 1
  1. #1

    my Extruder will not push out filiament

    i just bought a tevo tornado printer, i set it up and it ran like a charm at first, But after the second print my extruder will only print the thinnest layers you can imagine and then prints in the air.


    I checked my code, the layer hight did not change.

    i checked the motor that feeds filament into the hot end. works fine.

    I took the hot end apart and clean out the filament, i could almost breath through it.
    when i push the filament back in and push it in manaullyit comes out just fine.

    only when i print do i run into this issue.
    Last edited by 3Dprint_everything; 11-28-2018 at 08:50 PM.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •