Close



Results 1 to 7 of 7
  1. #1

    Smart Extruder + Explosion now it is encased in filament

    This extruder is only a couple months old. Thankfully I have a backup extruder. Do you think Makerbot will replace it?
    Attached Images Attached Images

  2. #2
    Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    558
    Add Roberts_Clif on Thingiverse
    Makerbot most likely will not replace. They however will sell you another.

    I would heat up the hot end as if I was going to print and remove the largest globs, using side cutters and needle nose pliers.
    After the majority is removed then depending on what filament you were printing would determine how I would proceed in cleaning the remaining filament

    If ABS I would use a jar or acetone and de-solve the remaining filament.
    If PLA I would slowly heat and scrape the filament from the parts until I had the more expensive retrievable parts.

    Then determine if it was worth my time to spend on the cheaper parts if not then throw the cheaper consumables away, and replace with new.

    Consumables
    Thermister
    Hot-End Heater
    Nozzle
    Hot-End Heater Block
    Last edited by Roberts_Clif; 11-25-2018 at 06:12 AM.

  3. #3
    Student murron-taylor's Avatar
    Join Date
    Jan 2019
    Location
    Japan
    Posts
    1
    what happens? how can it block? you can ask makerbot for help.

  4. #4
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    6,759
    'ask makerbot for help '
    Now that's funny :-)

    heat and remove, should come off easily enough.

    But for it to do that - it must have come out somewhere other than the nozzle.
    So you might need a new extruder.

  5. #5
    I had the exact same problem in November, too. I am having trouble finding a vendor for the Smart Extruder +. Have you had any success?

  6. #6
    Do you know where I can find replacement pieces for the Hot End and pices mentioned? Mine is the Smart Extruder +

  7. #7
    Were you able to find replacement parts? I have problems too. I need Hot end parts for the Smart Extruder +

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •