Results 1 to 5 of 5
-
06-08-2014, 09:45 AM #1
- Join Date
- May 2014
- Posts
- 18
An interesting looking Book for Teachers
There is an interesting book on Amazon now for teachers looking start 3D printing in the classroom. I haven't read it but I'm glad to see that there are now some resources for teachers to consider when bringing 3D printing to their classes.
It's titled "The Invent To Learn Guide to 3D Printing in the Classroom: Recipes for Success"
Anyone read it?
-
06-17-2014, 09:44 AM #2
- Join Date
- Jun 2014
- Location
- Florence, Italy
- Posts
- 5
Very good, thanks!
-
09-04-2014, 06:51 AM #3
I have bought this book and it's excellent. I have only had time for quick look but planning in reading and using it more in depth soon, I will post a review when done!
One of the issues I am encountering however is that different printers use different software and this could create confusion among educators, what software/hardware are you using?
Regards to all
Carlos
PS this is my first post!
-
02-03-2022, 12:59 PM #4
now there are many interesting books for both teachers and students
Last edited by Bikeracer2020; 12-02-2022 at 06:25 AM. Reason: link check
-
12-02-2022, 05:41 AM #5
- Join Date
- Dec 2022
- Posts
- 2
Schools usually buy different equipment that works completely differently. You can't forsee it to buy the "right" book.
Last edited by Bikeracer2020; 12-02-2022 at 06:26 AM. Reason: link check
What is the best material type for...
12-06-2024, 01:16 PM in General 3D Printing Discussion