Close



Results 1 to 4 of 4
  1. #1

    Sigma 3D Printer and My Quest to Build It

    Hi,

    I am a newbie who has always been interested in 3D printers but was reluctant to buy one, intimidated by the required technical knowledge. However, I have decided to bite the bullet and purchased a 3D printer kit recently from a local manufacturer based in Turkey. It is the second unit they have produced, so they are just getting in the businness. This is and will be a complete adventure for me as I have never performed any DIY type of work previously. I'll try to document everything related to the kit and its assembly. I'll also try to introduce basic concepts which, I think and hope, will be useful for beginners like me.

    Here's the link: http://www.3dprinterblog.org

    I am open to suggestions and advice.

    Thanks....

  2. #2
    Hi,

    I have added a blog entry about the motors used in the kit and also motors in general.

    Here's the link: http://www.3dprinterblog.org/2014/05...ts-motors.html

  3. #3
    Hi,

    I have added a new blog post on how to mount the Y motor and I also talk about the timing belts.

    Here's the link: http://www.3dprinterblog.org/2014/06...xis-motor.html

  4. #4
    Hi. I have added a new entry to the blog. Here's the link: http://www.3dprinterblog.org/2014/07...ators-and.html

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •