Close



Results 1 to 6 of 6
  1. #1
    Student
    Join Date
    May 2014
    Location
    Scotland
    Posts
    23

    Creator X led screen error?

    Hi again

    just fixed one problem and now my 3rd. Using my Galaxy Note to upload this picture of what happened to my Creator X screen half way through a print.

    No idea what to make of it. The screen is fine now but I was using the 2nd exude with glowy pla for the first time.

    Any ideas guys?

    Thanks
    Attached Images Attached Images

  2. #2
    Super Moderator Geoff's Avatar
    Join Date
    Nov 2013
    Location
    NSW, Australia
    Posts
    1,824
    Add Geoff on Thingiverse
    Quote Originally Posted by kingpiinx View Post
    Hi again

    just fixed one problem and now my 3rd. Using my Galaxy Note to upload this picture of what happened to my Creator X screen half way through a print.

    No idea what to make of it. The screen is fine now but I was using the 2nd exude with glowy pla for the first time.

    Any ideas guys?

    Thanks
    er... that is very odd, I cannot say I have ever seen it before. In the menu, you can go to firmware and check the version, what one are you guys running?
    Hex3D - 3D Printing and Design http://www.hex3d.com

  3. #3
    Student
    Join Date
    May 2014
    Location
    Scotland
    Posts
    23
    Sailfish FF Creator
    free SRAM 797
    Thing 32084 r01228
    Firmware version 7.6

    ....It says. Should i reset the motherboard you think?

  4. #4
    Super Moderator Geoff's Avatar
    Join Date
    Nov 2013
    Location
    NSW, Australia
    Posts
    1,824
    Add Geoff on Thingiverse
    Quote Originally Posted by kingpiinx View Post
    Sailfish FF Creator
    free SRAM 797
    Thing 32084 r01228
    Firmware version 7.6

    ....It says. Should i reset the motherboard you think?
    wow, I'm running firmware version 1.0.... I guess they updated a fair bit since that for the X...

    A factory reset will not hurt anything, might have to run a bed levelling setting and feeding extruders because it might make you go through the start up beginners script again (which can be run manually from my menu, not sure about yours)
    Hex3D - 3D Printing and Design http://www.hex3d.com

  5. #5
    Technician lucidpsykosis's Avatar
    Join Date
    Jul 2014
    Location
    Utah
    Posts
    95
    Follow lucidpsykosis On Twitter Add lucidpsykosis on Thingiverse
    Mine did that a couple days ago too
    Attached Images Attached Images

  6. #6

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •