Close



Results 1 to 8 of 8

Threaded View

  1. #1

    Unknown Print Failure

    Hi, this is my first post on this forum.

    Recently a part I was trying to print failed for a reason I can't determine. The printer is a Raise3d Pro2, printing Pro PLA 1.75mm filament.

    My settings were:

    - high quality template
    - 0.1mm layer height
    - 2 shells, 30% infill (model was small enough that it didn't use any infill)
    - 30mm/s outer, 50 mm/s inner
    - brim with 40 loop lines
    - 205 deg nozzle, 60 deg bed temperature

    I've attached some pictures. When I stopped the print, the job had come loose from the bed, but I don't know if that caused the failure or was caused by the failure.

    Can anyone offer any advice?
    Attached Images Attached Images

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •