Close



Results 1 to 2 of 2
  1. #1

    First print, total failure !

    Hello there, first post here.
    I just bought a 3d printer => Geetech prusa i3 b.
    I mounted myself ( a pain in the arse ) and i'm triyng to print the famous boat, the benchy one.
    Here's my settings ( i've tried Repeteier host and sclic3r or Cura ) :


    https://ibb.co/j5UR3A
    https://ibb.co/gFyxAq



    And that's the results..

    https://ibb.co/eA19qq
    https://ibb.co/mPffwV
    https://ibb.co/he1QVq
    https://ibb.co/bOREOA
    https://ibb.co/jbJTiA
    https://ibb.co/b9YuOA
    https://ibb.co/j10xbV

    Any tips? about the settings? Problem seems to be when i print very other layer but the first one which seems reasonable enough.

    Thanks in advance!

  2. #2
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    I would start with is the 3DBenchy the correct size.
    Measure the width and the length, the will tell you if the 3D Printer is printing to scale.

    If not to scale check your settings in the your slicer, below are my Printer settings.

    Cura top Menu
    Click Settings
    Select Printer Click
    Select Manage Printers
    Click Machine Settings

    Image3.jpg

    Not sure what firmware G-Code Geetech prusa i3 should use
    My bed Print area is 220 x 270 x 185mm
    M420 S1 and M220 S32.0000 may not apply to the your Geetech prusa i3, these are for my Auto bed leveling data restore function.
    Last edited by Roberts_Clif; 10-25-2018 at 06:42 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •