Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2
  1. 10-22-2018, 11:06 AM #1
    queylotrie
    queylotrie is offline
    Student
    Join Date
    Oct 2018
    Posts
    1

    Need help wiring 3d printer

    Hi!
    Im using a mains plug and cable which is connected to my heatbed and to the relay to circuit board. Im wondering where i should wire my earth wire of the mains cable? anybody know?
    Reply With Quote Reply With Quote
  2. 10-28-2018, 04:19 AM #2
    mbreznik
    mbreznik is offline
    Student
    Join Date
    Oct 2018
    Location
    Slovenia
    Posts
    4
    Add mbreznik on Facebook
    A few photos or schematic would be helpful for the community to give you advice.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules