Close



Results 1 to 6 of 6
  1. #1

    Makerbot chip blown

    Hi i have blown a chip on my board and i cant see what number it is due to the damage .
    I think its a voltage regulator i can only see the last 5 numbers which are 5970a .
    I attach a picture with the chip circled in red .
    If you want to know how i blew it , i connected the power the wrong way round loll.
    Thanks for any help.
    Attached Images Attached Images

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,818
    we are going to need a higher resolution picture (bigger).

  3. #3
    I have used a 20x magnifier and you cant see the first few digits of the chip , a higher res picture wont help i was hoping somone could look on thier good board and give me the number from that .

  4. #4
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,818
    point is, the picture you posted is too low res to see which chip you mean.
    There is no visible chip circled.

    So nobody can tell you because we don't know which chip you want identified :-)

  5. #5
    Click on the thumbnail and its circled in red top right hand corner just above the usb port.

  6. #6
    I have just looked at again with a microscope and i think it says LS970A but i can only find an LS970D . rather than waste time on it i have purchased an Anet board for ?13 and will just use that it will also give me auto leveling.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •