Close
Flash Forge Inventor Series



Results 1 to 2 of 2
  1. #1

    MakerBot Rep 2 - Circles

    I was just "gifted" a Makerbot Replicator 2 from a school building because they were having problems with it not printing circles correctly. All circles come out like ovals cat-eyes. The "short side" is on the Y. I have tried every adjustment that has been suggested all over the interwebs. What could I be missing?

    IMG_1915.jpg

    IMG_1918.jpg

  2. #2
    loose belt, bolts or bent frame? In a school it is not hard to imagine a trip from the table top to the floor... good luck!

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •