Close



Results 1 to 2 of 2
  1. #1

    Unhappy Printer "transfusion"

    Hello all, I'm not sure if this is the right spot to post this thread, but it's at least a start.
    I have a working controller board for a JGAurora A5, and I have a Creality Ender 3 with a dead controller board. How can I go about making the JGAurora controller board work with the Creality Ender 3?
    The part that I'm stuck on, in particular, is how should I go about configuring the firmware file to make this "franken-printer" work?

  2. #2
    Staff Engineer
    Join Date
    Jul 2016
    Location
    South Florida, USA
    Posts
    1,248
    Add AutoWiz on Facebook
    Personally I think you should goto ebay and look for a MKS GEN L board and get it with a MKS TFT32 touchscreen. I also think you should fill that board with tmc2208 stepper drivers. And the reason I feel that way is this: https://www.youtube.com/watch?v=UuDXfhSqMoQIt's quiet. Real quiet. and the screen responds to touch. Here is an earlier video of playing around with the touchscreen:https://www.youtube.com/watch?v=veQp-ANKWKE

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •