Close
Flash Forge Inventor Series



Results 1 to 2 of 2
  1. #1

    First layers squished?

    So at first I thought it was elephants foot. But alas it is not. 1st layer lays down perfect, but layers 2-6ish the nozzle doesnt seem to raise anywhere near enough. After that the print continues on just fine. It seems to only be a problem on solid prints like a brim or a raft (or the top part first few layers of a petsfang) Any ideas?

    TEVO Tornado Gold Edition
    PLA 210/60
    30mm/s bottom and top 2 layers, 60mm/s print.

  2. #2
    I am having the same problem with my Tornado. It makes it so that I can't print on rafts. They are always fused together. I have tried increasing the air gap but i can't find the right number.




    Quote Originally Posted by wbreslin951 View Post
    So at first I thought it was elephants foot. But alas it is not. 1st layer lays down perfect, but layers 2-6ish the nozzle doesnt seem to raise anywhere near enough. After that the print continues on just fine. It seems to only be a problem on solid prints like a brim or a raft (or the top part first few layers of a petsfang) Any ideas?

    TEVO Tornado Gold Edition
    PLA 210/60
    30mm/s bottom and top 2 layers, 60mm/s print.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •