Flash Forge Adventurer 3

Results 1 to 1 of 1
  1. #1

    Technical. Cura- Thin wall start/stop

    issue.jpgHiyaI was wondering if anyone of you came across this use. I`m trying to print 1.4mm wall, but for some reason, cura puts this funny infill even when i choose to go 100%.The work is not consistent and the print time is greatly extended.Thanks for any help.Please see pic.
    Last edited by mOSkit; 06-11-2018 at 07:40 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts