Close
Flash Forge Inventor Series



Results 1 to 4 of 4
  1. #1

    Problem second print Bl touch

    Hi everybody


    I have a problem with my Bltouch: I have read a lot of articles and it is far from simple;


    to launch the first print:
    g28;
    G29;
    m500;


    no problem the bed leveling is top


    however, to launch the second print


    g28;
    M420 S1 (to reactivate bed leveling)


    I lost the offset z and so it's bad because of what I read the G28 that makes a kind of reset


    Do you have an idea to keep the points? for a second impression


    Thank you !!

  2. #2
    Engineer-in-Training Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    226
    Add Roberts_Clif on Thingiverse
    Have you tried Z-Offset " M851 Z-0.44 " Sets the Z-offset the input -00.44

  3. #3
    Thanks but why -0.44 ? this number?

  4. #4
    Engineer-in-Training Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    226
    Add Roberts_Clif on Thingiverse
    That number is my Z-Height - You will set your own Z-Offset

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •