Close
Flash Forge Inventor Series



Results 1 to 2 of 2
  1. #1

    Inventor Build Volume

    The vertical Build volume for the Inventor is 160mm. I am working on printing a RC airplane. The tallest parts are 140mm high. At the very end of the build. about the last 1% the print head hits the model and damages the print. It acts life the build table is not going down any further, yet it still has an inch of travel left. Any ideas on what setting to mess with. I am using Simplify3D.

    In machine control panel 0,0,0 is right down to the bottom. I am at a loss.

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    5,981
    Only thing I can think of is to check your vertical endstop.
    Might have slipped. might not be properly fitted.

    Also make sure that you have the dimensions in correctly under the GCODE tab in simplify3d.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •