Hanging threads on verticals

[Gramps50]

Printing half of a stand to hold RC cars. I have printed the same file before with out issues but with a different filament, didn't have the issue. As you can see on the uprights there's strings hanging off. This is the 1st time I have seen this, had the fine hair like strands at times but nothing like this.






Printer: Wanhao Duplicator i3 Plus
Filament: Dazzle Light PLA
Temp: 210
Bed temp 60
Speed 60
Slicer Cura 3.04

To me it looks like it's travelling while still extruding if so what could be causing this?

[Roberts_Clif]

You are dripping filament while traveling, You can "enable retraction" and enable the Z hop to help eliminate this.

My Setting are
Minimum Travel (mm) 1.5
Enable combing All
Minimal extrusion before retracting (mm) .1
Z hop when retracting (mm) .075

[Gramps50]

I'll give that a try thanks