Close



Results 1 to 5 of 5

Thread: CR-10 Prusa I3

Hybrid View

  1. #1

    CR-10 Prusa I3

    33.jpgHi

    Set up the new printer..
    When I print the filament does not come out even, its thinner on one side....
    Please see the attached.
    The printer is a

    Aluminum 3D Printer Kit Creality CR-10 Prusa I3 Large Print Size 300x300x400mmAnyone know what would cause this?
    Thank you, tom
    I dont know if my picture is attaching..

    Last edited by tom356; 05-04-2018 at 04:45 PM.

  2. #2
    Super Moderator curious aardvark's Avatar
    Join Date
    Jul 2014
    Posts
    8,818
    could be a partially blocked nozzle - but no pic, so I'm guessing :-)

  3. #3
    33.jpgSorry tried a few time to attach a pic here. it did not work
    You can see it on the link..

    http://thinkgreenthinkclean.org/IMG_1608.JPG
    thank you

  4. #4
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    On my 3DP11/3DP12 3D-Printers it would mean the the right and left Z-Axis Steppers are out of alignment.

    I would align the Z-Axis equal on both right and left side of the bed. It appears that the nozzle is closer on the left side of the bed than on the right side of the bed.

    The auto bed leveling is suppose to correct for this up though.

    Oh!!!!!! Have you preformed the auto bed leveling.

  5. #5
    Thank you, leveling helped..

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •