BlTouch on Hictop Prusa i3

[Jmarc]

Hello,
I've installed the sensor and updated the firmware to marlin 1.1.8. However, when i try the auto bed level, it crashes on the bed.
Also, when i manually move my Z axis 1mm, it moves a lot more (+- 8mm).
The white and black are plugged in to the Z- socket and the other 3 on the D11 pins.
I've asked hictop to send me the original firmware but, haven't heard anything from them.
Board is MPX.3

I can't attach a zip of my firmware configs. Ask for parts of it and i'll provide it.
Any help would be greatly appreciated

[Roberts_Clif]

Hello;

Hictop software can be downloaded from the Hictop's web Page. Under the Tab "Download" drop down box "Firmware, Software" Then select the printer you have for the download.

https://hic-3d-printer.myshopify.com/

I have setup all versions of Marlin 1.1.X for 3DP11 and 3DP12 Aluminum Frame though do not have a BL-Touch I use a TL-W3MC2
If you need help with Marlin I could assist.

B0242_TL-W3MB_E.jpg

[Jmarc]

Thanks for the info, i've replaced the firmware with the one from the one i downloaded from the hictop site and was able to fix the Z motion so it now moves correctly.
I can't seem to be able to upload a zip from my marlin 1.1.8 firmware folder but, i've put my configuration.h file into a txt that i'm attaching here.
If you have any pointers, it would be greatly appreciated.

Thanks

[Roberts_Clif]

I do not see a Marlin 1.1.8 Configuration.h file attached file is for a much older version.

Try This " https://drive.google.com/open?id=1Gh...ibTgbl5ZUd1XAw "

Compiles With Arduino 1.8.4

[Jmarc]

Thanks a lot buddy, Z- i now working fine.
Now i just have to figure out my offset, approx 2-3 mm from the bed.

Have a great weekend

[Roxy]

Thanks a lot buddy, Z- i now working fine.
Now i just have to figure out my offset, approx 2-3 mm from the bed.

Have a great weekend

Home the printer... And then lower the nozzle .1mm at a time until the nozzle touches the bed. If your LCD Display says the Z axis is not at 0.000 mm, you need to add the stated Z value to your Z_PROBE_OFFSET value.