Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 02-05-2018, 11:22 AM #1
    TTVert
    TTVert is offline
    Technician
    Join Date
    Feb 2017
    Posts
    79

    Small blobs/stringing while traveling, is this a retraction setting issue? +PIC

    I don't think I see this that often but I did notice it on this print. I was able to pull it off as it wasn't adhered but the blobbing between the stringing has me confused. I'm using maker select w/ 1.75 PLA at 205. Retraction is at 4mm @40mm/sec. I took this directly from the maker select (Wanhao duplicator i3) specific cura so I would assume it would be accurate but who really knows? Travel speed is 150mm/sec.

    Thanks much,
    Dave
    Attached Images Attached Images
    Reply With Quote Reply With Quote
  2. 02-06-2018, 11:05 PM #2
    TTVert
    TTVert is offline
    Technician
    Join Date
    Feb 2017
    Posts
    79
    Anyone have an opinion?
    Reply With Quote Reply With Quote
  3. 02-07-2018, 06:00 AM #3
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,141
    Add Roberts_Clif on Thingiverse
    Enable Retraction, and maybe Z Hop when retracting.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules