Einscan-SE to SP conversion

[jmch]

Hello I am new to this forum I recently purchased an Einscan SE however the previous owner didn't have the calibration board and stand. Could someone please scan the board or measure the key dimesnsions dot size and outside board dimensions. I was planning on recreating the board by printing on card and using a aluminuim back plate. I have contacted Einscan to request availability to procure but no response at present. Any help appreciated. Thanks

Hi,Here's a scan as you asked:https://www86.zippyshare.com/v/l62CKex5/file.html

[yarmon1]

Hi thank you very much do I need a password as I have the forbidden page when I click on the link

[jmch]

Hi thank you very much do I need a password as I have the forbidden page when I click on the link

Perhaps a problem with your config. The link is OK here for now.Impossible to send with the board upload because the size limitation.

[bwtbd69]

This is so awesome, thank you for sharing! I knew that they were the same scanner but I didn't think you could get the features of the SP with the SE.

[Dr.Jorge]

Hello, I have looked everywhere for the software but I can't find it, can you help me?
the download link doesn't work

[Dr.Jorge]

Hi, can you help me I don't have version 3.0.0.1
the download link in this post does not work.

gracias

[jmch]

Another link : https://multiup.org/download/4811369...S_v3.0.0.1.exe

[noaccountingfortaste]

Another link : https://multiup.org/download/4811369...S_v3.0.0.1.exe

this one is down as well and i just got a new computer. any chance you could link it up again?