Anet a8 Def error ohm reading

[eligri]

Stopped working again :/

I have to check, the ones marked in yellow are capacitors, right?

[eligri]

I solved it! Removing both those capacitors, and not bridging, did the trick. Just two blank spots, where I had circled in the picture.

[eligri]

Just removed them completely and that is it? Nice.

Yep! 5-6 prints done so far, no issues The thermistor on the heatbed is a bit messed upp though, but no biggie. It is reading about 20C higher than it is, but have a new one on the way, and its working fine as long as I set the heatbed to 70C in Cura.