Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13
  1. #11
    Stopped working again :/

    I have to check, the ones marked in yellow are capacitors, right?
    Attached Images Attached Images

  2. #12
    I solved it! Removing both those capacitors, and not bridging, did the trick. Just two blank spots, where I had circled in the picture.

  3. #13
    Quote Originally Posted by number40Fan View Post
    Just removed them completely and that is it? Nice.
    Yep! 5-6 prints done so far, no issues The thermistor on the heatbed is a bit messed upp though, but no biggie. It is reading about 20C higher than it is, but have a new one on the way, and its working fine as long as I set the heatbed to 70C in Cura.

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts