I have a Flashforge Creator X that I bought from a co-worker. It worked fine for a while but then started exhibiting a strange problem when printing. It almost seems like it is not extruding enough plastic when printing. The raft prints fine, but then everything after that is very thin. The picture shows two prints. The one in green I printed a few weeks ago, the pink I printed today. I had switched to the pink spool as I was concerned I had a problem with the green filament as it was doing the same thing. I have throughly cleaned both heads, the ptfe tubes are good, and I cleaned the extruder gears. I am using Simplify3D plugged directly into the printer (eliminated the Astrobox just to make sure) and used the default settings for the high quality setting.
IMG_3476.jpg