Mamba3D - open source 3D-printer now on Kickstarter

[Eddie]

Yet another 3D Printer has launched a campaign on Kickstarter today. It's the Mamba3D Printer, which is an open source printer that is priced starting at 625Euros ($864). The printer is made completely of metal, and has a nice 200x200x200mm build area.



It uses 1.75 mm filament, has a .4mm nozzel and prints in a resolution up to 50 microns. It also uses an all metal hot-end.



The prints that they have as examples look really good too.


The Mamba3D printer is a complete kit consisting of:

• Aluminum frame and plates
• Electronics with preloaded firmware
• Motors, wires etc. [no soldering needed]
• Mamba3D extruder drive
• Hot-end
• All other hardware needed to build your own printer
• Detailed build manual
• Samplepack of premium Colorfabb PLA to get you started

Have any of you backed it?

[Mamba3D]

Thanks Eddie for mentioning the Mamba3D.

[Simon123]

I backed this neat project! Just a few more backers needed in the next few hours, I'm sure we can make this work. It looks to be a pretty cool printer.