Flash Forge Inventor II Spring Promotion

Results 1 to 2 of 2
  1. #1

    Filament coming out in preheat and during a print when it's not supposed to

    Every time the nozzle is heated PLA filament leaks out, even during a print when it's going over something it's not supposed to print. This has happened since I got my QIDI X-One a couple days ago. I have been told to just "grab it with a pliers" but that's not practical during the print. I am new to printing so I might need to adjust something on the printer.

    Here is a print where the extruder has to go back and forth between two columns, leaving filament suspended in the print.

  2. #2
    I am using Cura.

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts