Close



Results 1 to 3 of 3
  1. #1

    Best slicer for Qidi Tech (Replicator Dual Clone)?

    I am using currently the Makerbot (3.10.0.1364) software as slicer.
    On most of my prints there is a problem with the lower 5-6 mm, primarily if there the part has rounded corners.
    I print mostly in ABS at 230C extruder and 110C platform temperature with a medium (0.2mm) resolution.
    Anything above this problem-zone comes out OK and has the correct dimensions.
    Any suggestions are welcome.

  2. #2
    Super Moderator
    Join Date
    Jun 2016
    Location
    Oklahoma
    Posts
    904
    For free you can try Flashprint. Select the Creator pro as the printer. I have used it a bit to test and seemed to go ok.
    Ultimately for ease of use Simplify 3D is probably your best bet but it'll cost you!

    I have also worked with Slic3r and got pretty good results so far but it has been a pain to set up, especially if it is new to you.

  3. #3
    Thank you, whirlybird. I will try Flashprint.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •