Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3
  1. 06-04-2017, 04:17 AM #1
    Camero737
    Camero737 is offline
    Student
    Join Date
    Jun 2017
    Posts
    2

    Wanhao i3 wont stop when my probe is activated (ramps1.4) PLEASE HELP

    I'm switching over my wanhao i3 that had a z probe with stock board and marlin to ramps with repetier firmware. It doesnt stop when my zprobe is activated. I use M119 and it shows that my zprobe and my z min(which is my probe in the min pins) is H when not activated and L when activated and i set the firmare to be normally closed. Please help
    Reply With Quote Reply With Quote
  2. 06-04-2017, 01:49 PM #2
    Roxy
    Roxy is offline
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,182
    If you have Repetier firmware.... You don't have Marlin. If you had Marlin firmware, I could help you.
    Reply With Quote Reply With Quote
  3. 06-10-2017, 04:31 PM #3
    Camero737
    Camero737 is offline
    Student
    Join Date
    Jun 2017
    Posts
    2
    i was using repetier but i figured it out on marlin, thanks though.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules