Close



Results 1 to 5 of 5

Thread: Print problem

  1. #1

    Print problem

    See attached picture. My Hictop printer has been printing great without issue, but recently started doing this. This is a 10x10x20mm test column. As you can see it is not smooth. Any ideas on what is causing this? I have y & x axis belts with no improvement.
    Last edited by kc7rqa; 04-11-2017 at 05:51 PM.

  2. #2
    Engineer ralphzoontjens's Avatar
    Join Date
    Nov 2013
    Location
    Tilburg, the Netherlands
    Posts
    534
    Follow ralphzoontjens On Twitter Add ralphzoontjens on Facebook Add ralphzoontjens on Shapeways Add ralphzoontjens on Thingiverse
    Can you post the picture again?

  3. #3
    I have tried. Does not seem to be working.

  4. #4
    Engineer ralphzoontjens's Avatar
    Join Date
    Nov 2013
    Location
    Tilburg, the Netherlands
    Posts
    534
    Follow ralphzoontjens On Twitter Add ralphzoontjens on Facebook Add ralphzoontjens on Shapeways Add ralphzoontjens on Thingiverse
    Uploading a smaller picture usually works better.
    It is likely to do with your flow and temperature settings.
    But it can also be that a component of your print bed assembly or end stop mounts are loose.

  5. #5
    Can you post the picture again?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •