Results 1 to 1 of 1
  1. #1

    G-code Cooling fan questions

    Hey guys im currently printing a Marvin and i cant seem to get my side cooling fan to activate for active cooling to get a bit better quality on small prints.

    I have my First Layer Settings for

    First Layer H: 90%
    FIrst Layer W: 100%
    First Layer Spd: 50%

    and for cooling i have

    Layer Fan Speed
    1 0
    2 100

    Speed overrides

    checked off for adjust printing speed for layers below 15 sec allow speed reductions down to 20 %

    So my question is how do i start active cooling at the start of prints also when would the fan turn on during this print?

    i am using simplify3d for my slicer
    Last edited by Azn; 03-05-2017 at 05:54 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts