Subscribe to Our Newsletter Advertise
Close



Results 1 to 2 of 2
  1. 02-28-2017, 06:32 PM #1
    Alegence
    Alegence is offline
    Student
    Join Date
    Feb 2017
    Posts
    3

    .8 nozzle troubleshooting

    I have a monoprice maker select printer and I am using Cura as my splicer. I have been using a .4 nozzle and have had a lot of success with the printer, but I recently bought a mk10 .8 nozzle for an upgrade and now the printer will touch the bed, then begin the print and print 1 to 1.5 millimeters above the bed. I am not sure why a .8 nozzle would cause my slicer to have it print that high but is there a way to fix this issue?
    Reply With Quote Reply With Quote
  2. 02-28-2017, 06:36 PM #2
    Alegence
    Alegence is offline
    Student
    Join Date
    Feb 2017
    Posts
    3
    Another question! I am barely printing at 1.5mms per second, is that speed too low for my printer?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules