Troubleshooting TPE w/ Powerspec I3 plus

[SmoothVoltron]

New to 3D printing and I could use some advice on what my prints are trying to tell
me, the following is done is Cura.

First Print

• Print speed - 30mm/s
• Print temp. - 235°
• Bed temp. - 55°
• Initial layer thickness - 0.3
• Initial layer line width - 100

*Printer set to run it at 35% from there moved up to 55%. No advanced speed changes

Second Print

• Print speed - 15mm/s
• Travel speed - 15 mm/s
• Bottom layer speed - 15 mm/s (rest of advanced speeds set to 0 to match print speed)
• Print temp. - 235°
• Bed temp. - 55°
• Initial layer thickness - 0.3
• Initial layer line width - 100

*Flow increased by 5% (105%) resulted in a slightly better base. Yet still faulted when layering the ends of the dpad.