I have a Prusa 10" i3V, with a clough42 Z Probe for auto leveling, and clough42 extruder cooling shroud.

I am looking for a good solution for a print cooler.
Below is a photo of my current setup. It is what has worked best for me so far, has made a big improvement on my PLA prints.
BUT,,,, its also cooling the extruder tip too much, and I can not run the print cooler fan when I print with ABS.
I will set the nozzle to 242 degrees and if the fan is on, it can not maintain that at all, it will be more like 215 degrees

What is everyone else running? Any tips or suggestions would be great, thanks.