Close
Flash Forge Inventor Series



Results 1 to 2 of 2
  1. 12-28-2016, 10:59 PM #1
    stretch
    stretch is offline
    Student
    Join Date
    Dec 2016
    Posts
    1

    Question QU-BD Two up settings

    Does anyone know the eeprom settings for the two up?
    When I received my printer there wasn't anything on the board when I hooked it up to repetier.
    I can't seem to get it to move accurately either in mm or inches.
    If anyone has the eeprom settings, it would be gratefully appreciated.
    Thank you
    Reply With Quote Reply With Quote
  2. 09-30-2018, 01:38 PM #2
    Honey_badger
    Honey_badger is offline
    Student
    Join Date
    Sep 2018
    Posts
    2
    You will need to upload the Marlin firmware to the board. You can PM me if you need the file.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules