Close
Flash Forge Inventor Series



Results 1 to 2 of 2
  1. #1

    Question QU-BD Two up settings

    Does anyone know the eeprom settings for the two up?
    When I received my printer there wasn't anything on the board when I hooked it up to repetier.
    I can't seem to get it to move accurately either in mm or inches.
    If anyone has the eeprom settings, it would be gratefully appreciated.
    Thank you

  2. #2
    You will need to upload the Marlin firmware to the board. You can PM me if you need the file.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •